Tele-vue Qwik-Point (QBT-1006) Manuel d'utilisateur télécharger pdf

32 Elkay Drive, Chester, New York 10918 845.469.4551 www.televue.com

V3/01/07

(QBT-1006) QWIK-POINT INSTRUCTIONS

WARNING: DO NOT LOOK AT THE SUN. INSTANT AND PERMANENT DAM-

AGE TO YOUR EYES WILL OCCUR.

INTRODUCTION & USE

Qwik-Point uses a beam splitting mirror/lens to combine the scene through the lens

with a red dot projected by

it. The red dot indicates

where your telescope is

pointed. To aim you telescope with Qwik-Point, view the de-

sired object with both eyes. Do not close one. You can also be

any distance behind Qwik-Point. Swing your scope toward the object, allowing one

eye to look through the Qwik-Point lens. When Qwik-Point ‘s dot is on the object,

look through your scope.

COMPONENTS

The QWIK-POINT unit contains the light source, mirror/lens, on-off switch, battery

azimuth and elevation adjustment screws, and clamp screws

for the adapter bar.

The adapter bar permits

mounting Qwik-Point on a variety of

scopes.

MOUNTING

Loosen clamp screws on Qwik-Point

and slide the adapter out toward the back of

the unit.

For Tele Vue Ring Mounts use one or two #10-32 socket head

cap screws for mounting. Ranger models with slotted rear housings require one

#10-32 screw and Ranger models with just a threaded hole in the rear housing

requires a #6-32 button head screw ½” long.

For telescopes with different radius tubes, file or sandpaper the adapter bot-

tom concave to match the tube shape and cement (contact cement) or

screw the adapter to the tube.

Additional adapters (QPA-1004) may be purchased.

ALIGNMENT

With a low power eyepiece in the scope, find a suitable alignment sub-

ject and place it in the center of the field. With a Phillips head screw

driver, turn the horizontal and vertical adjustment

screws until Qwik-Point ‘s red dot is pointed to

the subject. Your scope and Qwik-

Point are now aligned. If you remove

Qwik-Point, check the alignment upon

reinstallation.

CARE

To replace the 3V lithium battery: slide out the battery and install a new battery with

the (+) face down.

Clean the lens by blowing dust off with a puffer brush. Remove grease with a

cotton swab moistened with lens cleaning fluid.

QWIK-POINT INSTRUCTIONS 1

Résumé du contenu

Page 1 - QWIK-POINT INSTRUCTIONS

32 Elkay Drive, Chester, New York 10918 845.469.4551 www.televue.comV3/01/07(QBT-1006) QWIK-POINT INSTRUCTIONSWARNING: DO NOT LOOK AT THE SUN. INS

Commentaires sur ces manuels

Pas de commentaire

Tele-vue Qwik-Point (QBT-1006) Manuel d'utilisateur

Naviguer en ligne ou télécharger Manuel d'utilisateur pour Optique Tele-vue Qwik-Point (QBT-1006). Tele Vue Qwik-Point (QBT-1006) User Manual Manuel d'utilisatio

Résumé du contenu

Commentaires sur ces manuels

Produits connexes et manuels pour Optique Tele-vue Qwik-Point (QBT-1006)